Skip to main content
Prescott, WI · River Falls Metro Mon–Fri 8a–5p · Sat by appt Owner-operated · Veteran-friendly

Patios & Porches · Prescott, WI · Est. 2003

Patios & Porches in Prescott, Wisconsin.

Prescott sits at the confluence of the St. Croix and Mississippi Rivers in Pierce County, where the two rivers meet at the Minnesota-Wisconsin border. About 20 minutes south of River Falls — one of the closest towns we serve. We install polyurea + polyaspartic floor coatings for Prescott homeowners — diamond-ground prep, custom flake colors, 1–2 day install, written 15-year warranty. Heavy mix of historic homes downtown (some dating to the 1850s-1880s when Prescott was a riverboat town), mid-century homes on Bluff Road and North Prescott, and newer builds along the Highway 35 corridor toward River Falls.

Patios & Porches in Prescott

What an install looks like in Prescott.

Prescott is small but has one of the more interesting slab profiles in our service area because it's a river-confluence town. The downtown blocks along Broad Street have homes built as early as the 1850s, back when Prescott was a riverboat hub. Those slabs have seen everything — multiple coatings, settlement, river-flood-cycle moisture, decades of salt damage. The diamond-ground prep handles it. The Mercord Mill area and homes along Bluff Road have mid-century slabs in better condition. Newer builds along the Highway 35 corridor toward River Falls have post-1990 slabs that grind cleanly. Because Prescott is only 20 minutes south of our shop, we frequently schedule installs the same week as quotes — lead times here are the shortest in our service area outside River Falls itself.

Patios & Porches specifically in Prescott

Prescott patios face Wisconsin freeze-thaw plus river-adjacent humidity. We schedule patio installs for the driest weather window we can find — typically late June through early September — and always run a moisture meter before coating. Polyurea + UV-stable polyaspartic is the only system that survives the climate; epoxy yellows and cracks within two seasons here. Anti-slip aggregate is standard for shaded north-facing patios and any patio along the river bluff that catches morning fog. Historic homes with brick or stone patios aren't candidates for coating — we route those quotes differently.

Neighborhoods we work in

  • Downtown / Broad Street
  • Bluff Road
  • North Prescott
  • Mercord Mill area
  • Highway 35 corridor
  • Pierce County edge
20+ Years installing Exterior coatings since 2003
1DAY Typical install Walk in 24h
LifeTIME UV warranty Won't yellow, ever
5.0 Google rating From real homeowners

Why we don't install epoxy in Prescott

Why acrylic sealers and epoxy fail outside — and what we install instead.

Most "concrete patio sealer" products at the box store are clear acrylics. They wear off in 12-24 months and offer minimal protection in the meantime. Epoxy is worse — yellows in sunlight within a year, then cracks the first winter. Both products fail on the basic problem: Wisconsin's freeze-thaw cycles demand flexibility and direct UV exposure demands UV-stable chemistry. Polyaspartic delivers both.

Acrylic Sealer / Box-Store Epoxy What you'll find at the home center
  • Acrylic sealers wear off in 12-24 months. Foot traffic, freeze-thaw, and UV exposure break down acrylic surface coatings fast. You're back at the home center every spring re-applying.
  • Epoxy yellows within a summer. Direct sunlight on epoxy turns it amber within months. By the second summer the floor looks chalked and aged.
  • Both crack across freeze-thaw. Wisconsin slabs expand and contract violently through winter. Rigid coatings fracture along the joints, then water gets under them, then the coating peels.
  • No real slip resistance. Smooth acrylic and epoxy get dangerously slick when wet. People fall on coated patios in rain, especially on stairs and stoops.
  • Salt and ice melt eat the bond. Calcium chloride and rock salt are aggressive on cheap coatings. The bond fails at the slab interface and the coating lifts.
Polyaspartic Exterior System What we install
  • Lasts 15+ years outside. Polyaspartic is the same chemistry used on industrial bridges and parking decks. It's engineered for outdoor permanence, not seasonal touch-up.
  • UV-stable to the molecule. Polyaspartic doesn't yellow, ever. The UV-resistance isn't a top-coat additive — it's the resin itself. Lifetime no-yellow warranty.
  • Flexible. Moves with freeze-thaw. Polyaspartic is approximately 100% more flexible than epoxy. Wisconsin slabs move; the coating moves with them.
  • Anti-slip aggregate standard. Every exterior install includes a slip-resistant aggregate broadcast in the topcoat. Texture level is dialed to the application — aggressive for stairs, smoother for covered patios where bare-foot comfort matters.
  • Salt + ice melt resistant. Polyaspartic handles the chemicals Wisconsin winters throw at it. We've installed exterior coatings since 2003; the warranty exists because the failure mode genuinely doesn't happen.

If you've been pricing "concrete patio sealers" or "patio epoxy," polyaspartic is the upgrade those terms should resolve to. Higher upfront cost than acrylic ($8-10 / sq ft vs $0.50-1.00 / sq ft for sealer), dramatically longer lifespan, and you're not back at the home center every spring.

Prescott Pricing

Patios & Porches cost in Prescott, WI: $7–9 per sq ft.

Pricing is upfront. Every number includes diamond-ground prep, polyaspartic system, anti-slip aggregate, your color choice, and the lifetime no-yellow warranty. Exterior installs price slightly higher than interior because polyaspartic resin costs more than polyurea + the prep work has to handle weather damage on the slab.

Small / Covered

150 sq ft

small covered patio or porch

From $1,200 to $1,500
  • Polyaspartic decorative flake
  • Anti-slip aggregate
  • Spalling repair if needed
  • Done in 1 day
Get my number
Most Common

250 sq ft

typical patio

From $2,000 to $2,500
  • Polyaspartic decorative flake
  • Anti-slip aggregate
  • Crack & joint repair
  • Done in 1 day
Get my number
Large / Open-Air

400+ sq ft

large patio or wraparound

From $3,200 to $4,400
  • Quartz system for direct weather
  • Maximum slip resistance
  • Phased install possible
  • Done in 1-2 days
Get my number

Stoops, steps, and walkways often combine with a patio job for bundled pricing — equipment is already on-site, so adding ~50-100 sq ft of stairs or path runs $400-800 instead of standalone pricing. Send four photos and Dave will text back a real number same-day.

The 6-step install

How we install your floor in Prescott.

Same checklist on every floor. The reason our coatings still look new at year ten when the cheap stuff peeled in year two.

  1. 01

    Diamond grinding

    Industrial diamond-tooled grinders open the concrete pores and remove old sealers, paint, and weather-damaged surface layer. Concrete that's been exposed to weather for years has a weakened top — grinding removes it down to sound substrate.
  2. 02

    Crack repair + spalling patch

    Cracks get filled with flexible polyurea joint filler. Spalled areas (where the surface has flaked off in chunks) get rebuilt with polymer-modified concrete repair compound. Soft or unsound areas are addressed before any coating goes down.
  3. 03

    Polyaspartic basecoat

    Full polyaspartic basecoat, not polyurea-base. Polyaspartic is UV-stable from the resin up — there's no risk of substrate yellowing showing through the topcoat over time.
  4. 04

    Anti-slip aggregate broadcast

    Kiln-dried silica sand or decorative flake is broadcast into the wet basecoat. Density and aggressiveness dialed to the application — heavier for stairs, lighter for covered patios where bare-foot comfort matters.
  5. 05

    Polyaspartic UV topcoat

    Final UV-stable polyaspartic topcoat seals the system. This is the layer that delivers the lifetime no-yellow warranty + handles direct sunlight, rain, snow, and salt without degradation.
  6. 06

    Written 15-year + lifetime UV warranty

    15-year written warranty against chip, crack, and peel under normal exterior use. Lifetime warranty against UV fading on the topcoat. The exterior warranty document is handed to you at install completion.

Prescott questions

Common questions for Prescott homeowners.

Do you handle historic homes in downtown Prescott?
Yes — and we do them often. Some downtown Prescott homes have slabs from the 1850s-1880s. Multiple prior coatings, settlement cracks, surface damage from a century-plus of river-town living. Diamond grinding removes whatever's there and the polyurea system bonds reliably to clean substrate. Expect more prep time than a newer-build install — typically 1.5-2 days vs 1 day.
Is moisture from the rivers a problem for Prescott basements?
Sometimes. Slabs within a few blocks of either river — most of downtown, the Mercord Mill area, and the river-bluff homes — pull more humidity than inland sites. We run a calcium chloride MVER moisture test on every below-grade install in Prescott. Most clear for a standard polyurea install; some get a moisture-mitigation primer first.
How fast can you get to Prescott from River Falls?
About 20 minutes south via Highway 35. Prescott is one of our shortest drives, so lead times are short — typically 1-2 weeks out from quote. We sometimes squeeze Prescott jobs into the same day as River Falls installs when the morning slot opens up. Text Dave four photos and a same-day ballpark is normal.
Is polyaspartic better than acrylic sealer for a concrete patio?
Yes, by 10-15× the lifespan. Acrylic sealers wear off in 12-24 months and offer minimal protection. Polyaspartic lasts 15+ years, doesn't yellow, doesn't peel, doesn't need re-application. The math: 5 acrylic re-seals over 15 years (DIY ~$200 each + labor) vs. one polyaspartic install ($2,000-2,500 for a typical 250 sq ft patio) that's done. The professional install is competitive on lifecycle cost and dramatically better-looking the entire time.
How much does a concrete patio coating cost in Wisconsin?
Polyaspartic patio coatings in River Falls, WI run $8-10 per square foot fully installed. A typical 250 sq ft patio is $2,000-2,500 all-in. Larger patios (400+ sq ft) come in at $3,200-4,400. Bundling stoops or walkways with a patio job runs ~$400-800 less than standalone because the equipment is already on-site.
Will the patio coating crack through Wisconsin winters?
Polyaspartic is engineered for slab movement and freeze-thaw. The basecoat is roughly 100% more flexible than epoxy and moves with the concrete through temperature swings. We've installed exterior coatings across western Wisconsin and the east Twin Cities since 2003 — the cracking failure mode genuinely doesn't happen on a properly prepped polyaspartic install.
Will it yellow in the sun?
No. Polyaspartic is UV-stable to the molecular level — the chemistry doesn't yellow, ever. We back this with a separate lifetime warranty against UV fading. Epoxy yellows within a summer; polyaspartic does not.
Is the patio surface slip-resistant when wet?
Yes. Every exterior install includes anti-slip aggregate broadcast into the topcoat. Texture level is calibrated to the use case — aggressive for stairs and stoops (where wet feet must not slip), smoother for covered patios where bare-foot comfort matters. We discuss the texture preference at the on-site quote.
When is the best time to coat a patio in Wisconsin?
Spring (April-June) and fall (September-October). The slab needs to be dry and the air temperature between roughly 50°F and 85°F for proper cure. Summer humidity slows it; winter is too cold. Exterior season is short in Wisconsin so book 4-6 weeks ahead during peak months.
Can you coat over an old, peeling concrete sealer?
Yes — diamond grinding removes most old sealers, paints, and previous coatings cleanly. Anything that doesn't come off with grinding gets addressed before the new system goes down. By the time the polyaspartic basecoat is rolled on, the slab is clean substrate.
What about spalled or chipped concrete — can you still coat it?
In most cases, yes. Spalled areas get rebuilt with polymer-modified concrete repair compound during prep, then the coating goes over a smooth surface. The exception: slabs that are structurally compromised (significant frost heave, deep spalling, foundation issues) should be replaced, not coated. Dave will tell you straight if your slab needs replacement instead of restoration.
What's covered under the warranty for an exterior coating?
15-year written warranty against chip, crack, and peel under normal exterior use. Lifetime warranty against UV fading. Exclusions: damage from abuse (vehicle parking, dropped weights, etc.), neglect, or improper chemical exposure. The warranty document is real — handed to you at install completion.
Can you coat a wraparound porch or wood-and-concrete combo?
We coat the concrete portions only. If your porch is mixed wood deck + concrete, we coat the concrete and you handle the wood with a deck stain or coating separately. We can quote both portions at the on-site visit and recommend a wood finish that complements the concrete coating color.

More in Prescott

All the floor coatings we install in Prescott, WI.

Whatever the slab — garage, basement, patio, mudroom, commercial — same diamond-ground prep, same polyurea + polyaspartic system, same 15-year warranty. Bundle pricing if you book multiple rooms in one visit.

Talk to Dave

Ready for a patios & porches install in Prescott?

Send Dave four photos of your slab — he'll text back a real Prescott number same-day. No salesperson, no quote-bot, no follow-up calls.

  • Free on-site measurement in Prescott
  • Written 15-year warranty
  • No subcontractors, no upsells
PRESCOTT QUOTE

Tell Dave about your Prescott slab.

Text Dave (fastest) Call
This site uses cookies for analytics + ads attribution. Privacy · Cookies