Skip to main content
Oakdale, MN · River Falls Metro Mon–Fri 8a–5p · Sat by appt Owner-operated · Veteran-friendly

Patios & Porches · Oakdale, MN · Est. 2003

Patios & Porches in Oakdale, Minnesota.

Oakdale is a Washington County suburb directly east of St. Paul, north of Woodbury and west of Lake Elmo. Mix of established 1960s-80s housing and newer suburban infill. About 40 minutes west of River Falls. We install polyurea + polyaspartic floor coatings for Oakdale homeowners — diamond-ground prep, custom flake colors, 1–2 day install, written 15-year warranty. Predominantly mid-century to 1980s suburban housing with significant 1990s-2010s infill development. Older neighborhoods like Brookview Park and North Oakdale have 1960s-70s slabs; newer subdivisions like Hadley Avenue corridor have post-1995 builds.

Text Dave · 715-307-8302 See Pricing

Patios & Porches in Oakdale

What an install looks like in Oakdale.

Oakdale has more 1960s-80s housing stock than most east-metro suburbs we serve, which changes the install profile compared to newer-built Woodbury or Cottage Grove. Brookview Park, North Oakdale, and the established neighborhoods have older slabs that often need more prep — settlement cracks, occasional spalling, sometimes prior paint or DIY epoxy to remove. The Hadley Avenue corridor and South Oakdale have newer post-1995 builds that grind cleanly. Tanners Lake and Beaver Lake bring some lower-level humidity into play for homes within a few blocks of the water. Oakdale garages are predominantly 2-car attached residential on the older side, with some 3-car builds in the newer subdivisions. We batch Oakdale installs with Lake Elmo and Woodbury work — the three cities share borders along the I-694 / I-94 corridor.

Patios & Porches specifically in Oakdale

Oakdale patios face standard Minnesota freeze-thaw with the Twin Cities heat-island moderating the worst of it. Most homes have a poured concrete back patio 200-400 square feet, often combined with a small deck. Polyurea + UV-stable polyaspartic is mandatory outdoors here — epoxy can't survive even moderated winters. Lakeshore patios near Tanners Lake or Beaver Lake get extra moisture screening because overnight lake humidity keeps slabs damp longer than inland sites. Anti-slip aggregate is recommended for shaded patios and any patio adjacent to a pool. We schedule patio installs for the driest weather window we can find.

Neighborhoods we work in

  • Tanners Lake area
  • Beaver Lake area
  • North Oakdale
  • Brookview Park
  • Hadley Avenue corridor
  • South Oakdale / Walton Park
20+ Years installing Exterior coatings since 2003
1DAY Typical install Walk in 24h
LifeTIME UV warranty Won't yellow, ever
5.0★ Google rating From real homeowners

Why we don't install epoxy in Oakdale

Why acrylic sealers and epoxy fail outside — and what we install instead.

Most "concrete patio sealer" products at the box store are clear acrylics. They wear off in 12-24 months and offer minimal protection in the meantime. Epoxy is worse — yellows in sunlight within a year, then cracks the first winter. Both products fail on the basic problem: Wisconsin's freeze-thaw cycles demand flexibility and direct UV exposure demands UV-stable chemistry. Polyaspartic delivers both.

Acrylic Sealer / Box-Store Epoxy What you'll find at the home center
  • Acrylic sealers wear off in 12-24 months. Foot traffic, freeze-thaw, and UV exposure break down acrylic surface coatings fast. You're back at the home center every spring re-applying.
  • Epoxy yellows within a summer. Direct sunlight on epoxy turns it amber within months. By the second summer the floor looks chalked and aged.
  • Both crack across freeze-thaw. Wisconsin slabs expand and contract violently through winter. Rigid coatings fracture along the joints, then water gets under them, then the coating peels.
  • No real slip resistance. Smooth acrylic and epoxy get dangerously slick when wet. People fall on coated patios in rain, especially on stairs and stoops.
  • Salt and ice melt eat the bond. Calcium chloride and rock salt are aggressive on cheap coatings. The bond fails at the slab interface and the coating lifts.
Polyaspartic Exterior System What we install
  • Lasts 15+ years outside. Polyaspartic is the same chemistry used on industrial bridges and parking decks. It's engineered for outdoor permanence, not seasonal touch-up.
  • UV-stable to the molecule. Polyaspartic doesn't yellow, ever. The UV-resistance isn't a top-coat additive — it's the resin itself. Lifetime no-yellow warranty.
  • Flexible. Moves with freeze-thaw. Polyaspartic is approximately 100% more flexible than epoxy. Wisconsin slabs move; the coating moves with them.
  • Anti-slip aggregate standard. Every exterior install includes a slip-resistant aggregate broadcast in the topcoat. Texture level is dialed to the application — aggressive for stairs, smoother for covered patios where bare-foot comfort matters.
  • Salt + ice melt resistant. Polyaspartic handles the chemicals Wisconsin winters throw at it. We've installed exterior coatings since 2003; the warranty exists because the failure mode genuinely doesn't happen.

If you've been pricing "concrete patio sealers" or "patio epoxy," polyaspartic is the upgrade those terms should resolve to. Higher upfront cost than acrylic ($8-10 / sq ft vs $0.50-1.00 / sq ft for sealer), dramatically longer lifespan, and you're not back at the home center every spring.

Oakdale Pricing

Patios & Porches cost in Oakdale, MN: $7–9 per sq ft.

Pricing is upfront. Every number includes diamond-ground prep, polyaspartic system, anti-slip aggregate, your color choice, and the lifetime no-yellow warranty. Exterior installs price slightly higher than interior because polyaspartic resin costs more than polyurea + the prep work has to handle weather damage on the slab.

Small / Covered

150 sq ft

small covered patio or porch

From $1,200 to $1,500
  • Polyaspartic decorative flake
  • Anti-slip aggregate
  • Spalling repair if needed
  • Done in 1 day
Get my number
Most Common

250 sq ft

typical patio

From $2,000 to $2,500
  • Polyaspartic decorative flake
  • Anti-slip aggregate
  • Crack & joint repair
  • Done in 1 day
Get my number
Large / Open-Air

400+ sq ft

large patio or wraparound

From $3,200 to $4,400
  • Quartz system for direct weather
  • Maximum slip resistance
  • Phased install possible
  • Done in 1-2 days
Get my number

Stoops, steps, and walkways often combine with a patio job for bundled pricing — equipment is already on-site, so adding ~50-100 sq ft of stairs or path runs $400-800 instead of standalone pricing. Send four photos and Dave will text back a real number same-day.

The 6-step install

How we install your floor in Oakdale.

Same checklist on every floor. The reason our coatings still look new at year ten when the cheap stuff peeled in year two.

  1. 01

    Diamond grinding

    Industrial diamond-tooled grinders open the concrete pores and remove old sealers, paint, and weather-damaged surface layer. Concrete that's been exposed to weather for years has a weakened top — grinding removes it down to sound substrate.
  2. 02

    Crack repair + spalling patch

    Cracks get filled with flexible polyurea joint filler. Spalled areas (where the surface has flaked off in chunks) get rebuilt with polymer-modified concrete repair compound. Soft or unsound areas are addressed before any coating goes down.
  3. 03

    Polyaspartic basecoat

    Full polyaspartic basecoat, not polyurea-base. Polyaspartic is UV-stable from the resin up — there's no risk of substrate yellowing showing through the topcoat over time.
  4. 04

    Anti-slip aggregate broadcast

    Kiln-dried silica sand or decorative flake is broadcast into the wet basecoat. Density and aggressiveness dialed to the application — heavier for stairs, lighter for covered patios where bare-foot comfort matters.
  5. 05

    Polyaspartic UV topcoat

    Final UV-stable polyaspartic topcoat seals the system. This is the layer that delivers the lifetime no-yellow warranty + handles direct sunlight, rain, snow, and salt without degradation.
  6. 06

    Written 15-year + lifetime UV warranty

    15-year written warranty against chip, crack, and peel under normal exterior use. Lifetime warranty against UV fading on the topcoat. The exterior warranty document is handed to you at install completion.

Oakdale questions

Common questions for Oakdale homeowners.

Do you serve the older Oakdale neighborhoods like Brookview Park and North Oakdale?
Yes — those make up a lot of our Oakdale work. 1960s-80s slabs need more prep (edge spalling repair, settlement cracks, sometimes prior paint or 1990s epoxy to grind off) but the polyurea system bonds reliably to a properly prepped substrate. Expect 1.5 days for the older homes vs 1 day for the newer subdivisions.
Are Tanners Lake or Beaver Lake-adjacent homes more prone to moisture issues?
Slightly — lake proximity adds humidity to lower-level slabs. We run a calcium chloride MVER moisture test on every below-grade install within a few blocks of either lake. Most slabs clear for a standard polyurea install; some get a moisture-mitigation primer underneath. Either way you know up-front what your slab needs.
What about smaller 2-car garages in older Oakdale homes — do you still take those jobs?
Yes — Oakdale 2-car garages are some of our most common installs. The footprint is smaller (typically 400-440 sqft), the install runs a single day, and bundling a mudroom or utility room with the garage install keeps the second-room cost low. Older slab prep adds time but doesn't change the install pattern.
Is polyaspartic better than acrylic sealer for a concrete patio?
Yes, by 10-15× the lifespan. Acrylic sealers wear off in 12-24 months and offer minimal protection. Polyaspartic lasts 15+ years, doesn't yellow, doesn't peel, doesn't need re-application. The math: 5 acrylic re-seals over 15 years (DIY ~$200 each + labor) vs. one polyaspartic install ($2,000-2,500 for a typical 250 sq ft patio) that's done. The professional install is competitive on lifecycle cost and dramatically better-looking the entire time.
How much does a concrete patio coating cost in Wisconsin?
Polyaspartic patio coatings in River Falls, WI run $8-10 per square foot fully installed. A typical 250 sq ft patio is $2,000-2,500 all-in. Larger patios (400+ sq ft) come in at $3,200-4,400. Bundling stoops or walkways with a patio job runs ~$400-800 less than standalone because the equipment is already on-site.
Will the patio coating crack through Wisconsin winters?
Polyaspartic is engineered for slab movement and freeze-thaw. The basecoat is roughly 100% more flexible than epoxy and moves with the concrete through temperature swings. We've installed exterior coatings across western Wisconsin and the east Twin Cities since 2003 — the cracking failure mode genuinely doesn't happen on a properly prepped polyaspartic install.
Will it yellow in the sun?
No. Polyaspartic is UV-stable to the molecular level — the chemistry doesn't yellow, ever. We back this with a separate lifetime warranty against UV fading. Epoxy yellows within a summer; polyaspartic does not.
Is the patio surface slip-resistant when wet?
Yes. Every exterior install includes anti-slip aggregate broadcast into the topcoat. Texture level is calibrated to the use case — aggressive for stairs and stoops (where wet feet must not slip), smoother for covered patios where bare-foot comfort matters. We discuss the texture preference at the on-site quote.
When is the best time to coat a patio in Wisconsin?
Spring (April-June) and fall (September-October). The slab needs to be dry and the air temperature between roughly 50°F and 85°F for proper cure. Summer humidity slows it; winter is too cold. Exterior season is short in Wisconsin so book 4-6 weeks ahead during peak months.
Can you coat over an old, peeling concrete sealer?
Yes — diamond grinding removes most old sealers, paints, and previous coatings cleanly. Anything that doesn't come off with grinding gets addressed before the new system goes down. By the time the polyaspartic basecoat is rolled on, the slab is clean substrate.
What about spalled or chipped concrete — can you still coat it?
In most cases, yes. Spalled areas get rebuilt with polymer-modified concrete repair compound during prep, then the coating goes over a smooth surface. The exception: slabs that are structurally compromised (significant frost heave, deep spalling, foundation issues) should be replaced, not coated. Dave will tell you straight if your slab needs replacement instead of restoration.
What's covered under the warranty for an exterior coating?
15-year written warranty against chip, crack, and peel under normal exterior use. Lifetime warranty against UV fading. Exclusions: damage from abuse (vehicle parking, dropped weights, etc.), neglect, or improper chemical exposure. The warranty document is real — handed to you at install completion.
Can you coat a wraparound porch or wood-and-concrete combo?
We coat the concrete portions only. If your porch is mixed wood deck + concrete, we coat the concrete and you handle the wood with a deck stain or coating separately. We can quote both portions at the on-site visit and recommend a wood finish that complements the concrete coating color.

More in Oakdale

All the floor coatings we install in Oakdale, MN.

Whatever the slab — garage, basement, patio, mudroom, commercial — same diamond-ground prep, same polyurea + polyaspartic system, same 15-year warranty. Bundle pricing if you book multiple rooms in one visit.

Patios & Porches elsewhere

Patios & Porches in nearby cities.

Same diamond-ground prep, same polyurea + polyaspartic system, same 15-year warranty across our entire service area. If you're outside Oakdale, here's where else we install.

← See Patios & Porches details and full service area

Talk to Dave

Ready for a patios & porches install in Oakdale?

Send Dave four photos of your slab — he'll text back a real Oakdale number same-day. No salesperson, no quote-bot, no follow-up calls.

715-307-8302 Text Dave · Fastest reply
  • Free on-site measurement in Oakdale
  • Written 15-year warranty
  • No subcontractors, no upsells
OAKDALE QUOTE

Tell Dave about your Oakdale slab.

By submitting you agree to be contacted about your project. We don't sell your info, ever.

Text Dave (fastest) Call
This site uses cookies for analytics + ads attribution. Privacy · Cookies