River Falls, WI · East Twin Cities Metro Mon–Fri 8a–5p · Sat by appt Owner-operated · Veteran-friendly (715) 307-8302

Terrazzo Restoration · West St. Paul, MN · Est. 2003

Terrazzo Restoration in West St. Paul, Minnesota.

West St. Paul is a first-ring Dakota County suburb directly south of downtown St. Paul, up on top of the river bluff rather than down in the valley. Robert Street runs the length of it and carries most of the commercial ground. About 45 minutes from River Falls. Terrazzo restoration for West St. Paul schools, civic buildings and churches. We clean and seal the floor you have rather than grinding it, and the polish schedule ends.

Text Dave · (715) 307-8302 How It Works
0 Grinding The terrazzo stays as it is
1 Coat Applied over the existing floor
3-5YR Between coats Manufacturer rating in normal traffic
4-5HRS To foot traffic Corridors reopen the next morning

Why we do not grind terrazzo in West St. Paul

Why sealing beats grinding on most terrazzo.

Terrazzo is a poured floor of stone chips in a cement or epoxy matrix, and it is one of the longest-lived floors ever installed in a public building. Most of the terrazzo in Minnesota schools and civic buildings is older than the people maintaining it and structurally has nothing wrong with it. What is wrong is the finish on top.

The 6-step job

What the work looks like in West St. Paul.

The same sequence whether it is a school corridor, a church narthex or a courthouse lobby.

  1. Look at the floor

    What is on it, how many layers, whether it has been ground before, and how the edges and seams have held. Terrazzo hides its history under old finish, so this step decides the scope more than the square footage does.

  2. Strip what is on top

    Stripper dwells, then the floor is machine scrubbed in two directions with a slow-speed rotary. Edges, corners and the perimeter against the base get worked by hand. On terrazzo this is the step that takes the time, because decades of acrylic do not come off in one pass.

  3. Extract and neutralize

    The slurry comes up with a wet vacuum, then a citric acid scrub brings the surface back to neutral and we pH test to confirm it. Terrazzo is porous enough that a floor left alkaline will not hold a coating properly.

  4. Check the conditions

    Air temperature, humidity, floor temperature and dew point are read and recorded before mixing. Above 70 percent relative humidity the job stops. Heated buildings through the winter sit well inside the range, which is why most of this work is scheduled between October and April.

  5. Seal it

    Two technicians, one spreading and one back-rolling immediately behind, because the working window is short and terrazzo shows an uneven coat more than a patterned floor does. Traction additive goes in at this stage where the floor needs a higher slip rating, which on a school corridor it usually does.

  6. Hand it back

    The area stays closed until it is dry with the ready time posted on the door, and foot traffic goes back on in 4 to 5 hours on the fast formula. We go over maintenance with whoever cleans the building: dust mop, water, and nothing that adds a layer back on top.

West St. Paul questions

Common questions for West St. Paul homeowners.

Our garage is a narrow two-car from 1955. Is that too small to be worth coating?
No, and small garages are most of the work in West St. Paul. The prep is the same sequence at a smaller scale: diamond grind to bare concrete, fill the cracks with polyurea, rebuild the spalled edge at the door, then coat. A narrow garage does put the wall line closer to the traffic, so the coating runs all the way to the wall rather than stopping short.
There is a coat of gray paint on our floor. Does it have to come off?
Yes. Paint is the layer a new coating would be bonded to, and paint is not bonded to much. Diamond grinding takes it off and opens the concrete so the polyurea sticks to the slab itself. Old floor paint is normal on West St. Paul's post-war garages and it is prep, not a problem.
Do basements up on the bluff still need a moisture test?
They still get one. Bluff-top slabs in West St. Paul usually read low, which is good news, but 1950s construction did not always include a vapor barrier under the slab and the only way to know what a particular floor is passing is to measure it. A calcium chloride test answers it before anything is coated.
How does the cost compare to grinding and polishing?
Sealing is the less expensive of the two in nearly every case, because the labor is stripping and cleaning rather than multiple passes of diamond tooling, slurry extraction and dust containment. What moves our number is how much old finish has to come off, which on terrazzo is usually the bulk of the job. We walk the floor and give you a fixed written price before anything starts.
Will the aggregate and color come back?
On a floor that is dulled by old wax rather than physically damaged, yes, and it is usually the part people are not expecting. The chips and the color are still there under the build-up. Stripping takes the gray film off and the coat that goes on top wets the surface and brings the depth back. Terrazzo that has been ground through, cracked, or patched with mismatched material is a different conversation and we will tell you that on the walk.
Is grinding ever the better answer?
Yes. Terrazzo with deep damage, failed patches, lippage at the seams, or aggregate that has genuinely worn through needs material removed before anything goes on top. Sealing a floor in that condition locks the problem in. If that is what your floor needs, we will say so rather than quote the job we would rather do.
How long is the corridor closed?
Foot traffic returns 4 to 5 hours after the coat goes down on the fast formula, 8 hours on the slower one. Corridors get done in sections so no route through the building is closed for a full day, and most of this work is scheduled overnight or over a break anyway.
Can it be done over a school break?
That is when most of it happens. An empty building and dry winter air are both good for this work, and a two-week winter break is enough for a substantial amount of floor. Booking it takes some lead time, so the conversation usually happens a couple of months ahead of the break rather than the week before.
What about slip resistance on a school corridor?
The matte finish tests at 0.9 dry coefficient of friction and the gloss at 0.51. Where a floor needs more, a traction additive is mixed into the coating, which raises the slip rating and the abrasion resistance at the same time. Entries, stair landings and anywhere that takes snowmelt usually get it.
How is it cleaned afterward?
Dust mop, then damp mop with water or a neutral cleaner, and an auto-scrubber with a microfiber pad on the large open runs. No burnishing, no polishing, and nothing that leaves an acrylic layer behind. The floor equipment a building keeps for terrazzo mostly stops being needed.

More in West St. Paul

All the services we offer in West St. Paul, MN.

Buildings with terrazzo in the lobby usually have VCT in the classrooms and tile in the restrooms. All of it can be done on the same visit.

Terrazzo Restoration elsewhere

Terrazzo Restoration in nearby cities.

Terrazzo restoration in nearby cities.

← See Terrazzo Restoration details and full service area

Get a quote

Ready for a terrazzo restoration install in West St. Paul?

Terrazzo restoration in West St. Paul and the surrounding metro.

(715) 307-8302 Text Dave · Fastest reply
  • Free on-site measurement
FREE QUOTE

Tell us about the floor.

By submitting you agree to be contacted about your project. We don't sell your info, ever.

Text Dave (fastest) Call