River Falls, WI · East Twin Cities Metro Mon–Fri 8a–5p · Sat by appt Owner-operated · Veteran-friendly (715) 307-8302

Terrazzo Restoration · Star Prairie, WI · Est. 2003

Terrazzo Restoration in Star Prairie, Wisconsin.

Star Prairie is a St. Croix County village of about 700 on the Apple River, five miles north of New Richmond on Highway 65. It sits on the line between the Town of Star Prairie and the Town of Stanton, and a stream called Saratoga Spring joins the river in the middle of the village. About 50 minutes north of River Falls. Terrazzo restoration for Star Prairie schools, civic buildings and churches. We clean and seal the floor you have rather than grinding it, and the polish schedule ends.

Text Dave · (715) 307-8302 How It Works
0 Grinding The terrazzo stays as it is
1 Coat Applied over the existing floor
3-5YR Between coats Manufacturer rating in normal traffic
4-5HRS To foot traffic Corridors reopen the next morning

Why we do not grind terrazzo in Star Prairie

Why sealing beats grinding on most terrazzo.

Terrazzo is a poured floor of stone chips in a cement or epoxy matrix, and it is one of the longest-lived floors ever installed in a public building. Most of the terrazzo in Minnesota schools and civic buildings is older than the people maintaining it and structurally has nothing wrong with it. What is wrong is the finish on top.

The 6-step job

What the work looks like in Star Prairie.

The same sequence whether it is a school corridor, a church narthex or a courthouse lobby.

  1. Look at the floor

    What is on it, how many layers, whether it has been ground before, and how the edges and seams have held. Terrazzo hides its history under old finish, so this step decides the scope more than the square footage does.

  2. Strip what is on top

    Stripper dwells, then the floor is machine scrubbed in two directions with a slow-speed rotary. Edges, corners and the perimeter against the base get worked by hand. On terrazzo this is the step that takes the time, because decades of acrylic do not come off in one pass.

  3. Extract and neutralize

    The slurry comes up with a wet vacuum, then a citric acid scrub brings the surface back to neutral and we pH test to confirm it. Terrazzo is porous enough that a floor left alkaline will not hold a coating properly.

  4. Check the conditions

    Air temperature, humidity, floor temperature and dew point are read and recorded before mixing. Above 70 percent relative humidity the job stops. Heated buildings through the winter sit well inside the range, which is why most of this work is scheduled between October and April.

  5. Seal it

    Two technicians, one spreading and one back-rolling immediately behind, because the working window is short and terrazzo shows an uneven coat more than a patterned floor does. Traction additive goes in at this stage where the floor needs a higher slip rating, which on a school corridor it usually does.

  6. Hand it back

    The area stays closed until it is dry with the ready time posted on the door, and foot traffic goes back on in 4 to 5 hours on the fast formula. We go over maintenance with whoever cleans the building: dust mop, water, and nothing that adds a layer back on top.

Star Prairie questions

Common questions for Star Prairie homeowners.

Is Star Prairie too small a town to get a floor coated?
No. Star Prairie is five miles north of New Richmond on Highway 65, about 50 minutes from River Falls. A one-car garage or a small utility room is an ordinary job.
Our place is right on the Apple River. Does the water matter?
For a garage on grade, rarely. For a basement or a walkout down by the river, yes. The springs here run all year, so that ground stays wet in a way the prairie above it does not. We run a calcium chloride moisture test on those floors, and a high reading means a vapor-mitigation primer goes under the polyurea.
We are on a gravel road. Will the sand wear a coating out?
No. Sand and crushed rock scour bare concrete and dull floor paint, but a polyurea coating is a solid membrane and takes that kind of grit without cutting through. It also means you can sweep or hose the floor instead of grinding grit into the slab every time you drive in.
How does the cost compare to grinding and polishing?
Sealing is the less expensive of the two in nearly every case, because the labor is stripping and cleaning rather than multiple passes of diamond tooling, slurry extraction and dust containment. What moves our number is how much old finish has to come off, which on terrazzo is usually the bulk of the job. We walk the floor and give you a fixed written price before anything starts.
Will the aggregate and color come back?
On a floor that is dulled by old wax rather than physically damaged, yes, and it is usually the part people are not expecting. The chips and the color are still there under the build-up. Stripping takes the gray film off and the coat that goes on top wets the surface and brings the depth back. Terrazzo that has been ground through, cracked, or patched with mismatched material is a different conversation and we will tell you that on the walk.
Is grinding ever the better answer?
Yes. Terrazzo with deep damage, failed patches, lippage at the seams, or aggregate that has genuinely worn through needs material removed before anything goes on top. Sealing a floor in that condition locks the problem in. If that is what your floor needs, we will say so rather than quote the job we would rather do.
How long is the corridor closed?
Foot traffic returns 4 to 5 hours after the coat goes down on the fast formula, 8 hours on the slower one. Corridors get done in sections so no route through the building is closed for a full day, and most of this work is scheduled overnight or over a break anyway.
Can it be done over a school break?
That is when most of it happens. An empty building and dry winter air are both good for this work, and a two-week winter break is enough for a substantial amount of floor. Booking it takes some lead time, so the conversation usually happens a couple of months ahead of the break rather than the week before.
What about slip resistance on a school corridor?
The matte finish tests at 0.9 dry coefficient of friction and the gloss at 0.51. Where a floor needs more, a traction additive is mixed into the coating, which raises the slip rating and the abrasion resistance at the same time. Entries, stair landings and anywhere that takes snowmelt usually get it.
How is it cleaned afterward?
Dust mop, then damp mop with water or a neutral cleaner, and an auto-scrubber with a microfiber pad on the large open runs. No burnishing, no polishing, and nothing that leaves an acrylic layer behind. The floor equipment a building keeps for terrazzo mostly stops being needed.

More in Star Prairie

All the services we offer in Star Prairie, WI.

Buildings with terrazzo in the lobby usually have VCT in the classrooms and tile in the restrooms. All of it can be done on the same visit.

Terrazzo Restoration elsewhere

Terrazzo Restoration in nearby cities.

Terrazzo restoration in nearby cities.

← See Terrazzo Restoration details and full service area

Get a quote

Ready for a terrazzo restoration install in Star Prairie?

Terrazzo restoration in Star Prairie and the surrounding metro.

(715) 307-8302 Text Dave · Fastest reply
  • Free on-site measurement
FREE QUOTE

Tell us about the floor.

By submitting you agree to be contacted about your project. We don't sell your info, ever.

Text Dave (fastest) Call