River Falls, WI · East Twin Cities Metro Mon–Fri 8a–5p · Sat by appt Owner-operated · Veteran-friendly (715) 307-8302

Tile & Grout Sealing · Osceola, WI · Est. 2003

Tile & Grout Sealing in Osceola, Wisconsin.

Osceola is a Polk County village on the bluff above the St. Croix River. Cascade Falls, a 25-foot falls on Osceola Creek, drops through Wilke Glen in the middle of downtown, and Highway 243 crosses the river here into Franconia Township on the Minnesota side. About 55 minutes north of River Falls. Tile and grout cleaning and sealing for Osceola restrooms, kitchens, entries and corridors. We clean the floor, then seal the grout so it stops absorbing what gets mopped into it.

1 Coat Over the tile and the grout together
3-5YR Between coats Manufacturer rating in normal traffic
4-5HRS To foot traffic Restrooms reopen the same shift
0.9 Matte traction Dry DCOF, higher with aggregate

Why we seal the grout in Osceola

Why the grout is the part that matters.

Ceramic and porcelain tile is close to non-porous and it is harder than anything that can be put on top of it. Grout is the opposite. It is cement, it is full of open pores, and it sits a fraction of an inch below the tile face, which is exactly where mop water goes and stays. Almost every complaint about a tile floor is actually a complaint about the grout.

The 6-step job

What the work looks like in Osceola.

The same sequence whether it is a restroom, a commercial kitchen or a tiled entry.

  1. Look at the floor

    Tile size, joint width and depth, how much soil is in the lines, whether any grout has cracked or gone missing, and what has been used on the floor up to now. This is also where we tell you if your tile is a poor candidate, which large smooth tile often is.
  2. Clean the tile and the grout

    Cleaner dwells, then the floor is machine scrubbed and the grout lines are worked individually with a brush rather than passed over with a pad. Where there is old acrylic on the tile, that comes off first with stripper. Edges, corners and the base of every fixture get done by hand, because that is where the buildup is worst.
  3. Extract and neutralize

    The slurry comes up with a wet vacuum, then a citric acid scrub brings the surface back to neutral and we pH test to confirm it. Grout that is still alkaline will not let the coating bond, and grout is the part of the floor that holds the chemical longest.
  4. Check the conditions

    Air temperature, humidity, floor temperature and dew point are read and recorded before mixing. Above 70 percent relative humidity the job stops. Restrooms and kitchens hold moisture longer than the rest of a building, so this reading gets taken in the room, not in the hallway outside it.
  5. Seal it

    Two technicians, one spreading and one back-rolling immediately behind, so the coat wets into the grout lines evenly instead of bridging them. Traction additive goes in at this stage, which on a restroom or a kitchen floor it usually does.
  6. Hand it back

    The room stays closed until it is dry with the ready time posted on the door, and foot traffic goes back on in 4 to 5 hours on the fast formula. We go over cleaning with whoever maintains the building: damp mop with water or a neutral cleaner, and nothing that leaves a film behind.

Osceola questions

Common questions for Osceola homeowners.

Is Osceola too far north for you?
No. It is about 55 minutes from River Falls, straight up Highway 35 through Hudson and Somerset, on the same road as Somerset and St. Croix Falls.
Our house is on the slope above the glen. Should we worry about the basement floor?
It is worth testing rather than guessing. Osceola Creek is spring-fed, and the ground under the village drains toward the glen and the river, so a slab set into that slope can pass moisture year-round. A calcium chloride test gives us a number. A low number takes standard polyurea; a high one gets a vapor-mitigation primer underneath first.
Can you coat a pole barn or machine shed floor outside town?
Yes, and in the townships around Osceola that is a common job. A shop slab is bigger and flatter than a garage slab and takes heavier use: equipment weight, jacks, fuel and dropped steel. Polyurea is rated for that. The one thing to settle first is heat, because the slab has to be warm enough to cure.
What does it cost compared to having the grout scrubbed?
Square footage matters less here than the grout does. A floor with narrow joints and light soil cleans up quickly; small tile with deep lines and years of buildup is most of the labor on the job. We walk the floor and give you a fixed written price before anything starts. The comparison worth making is against what you are spending on grout cleaning every year, because once the grout is sealed it stops taking the soil on in the first place.
Will the grout go back to its original color?
Grout that is gray from soil rather than stained usually comes back a long way once the lines are cleaned properly, and the coat that goes over the top wets the surface and brings the color up further. What sealing does not do is recolor grout. Grout that has been permanently stained, or that was patched at some point with a different batch, stays the color it is, and you will see that on the walk before you decide anything.
Is it slippery in a restroom or a kitchen?
The matte finish tests at 0.9 dry coefficient of friction and the gloss at 0.51. On any floor that takes standing water we mix a traction additive into the coating, which raises the slip rating and the abrasion resistance together. Restrooms, kitchens, entries and anywhere that takes snowmelt get it as a matter of course.
Does it hold up to disinfectants?
Better than acrylic does, which is the reason this product exists. Quaternary disinfectants used in clinical and food areas break acrylic finish down directly, which is why those rooms end up on the shortest recoat cycles in the building. EPIC is tested against bleach, hand sanitizer, food acids, vinegar and motor oil.
Does this work on large-format tile?
It goes on, but on tile of roughly 12 inches and up there is little to gain. Most of that floor is tile, the tile is already harder and less porous than the coating, and the grout that would benefit is a small share of the surface. Small tile with a lot of grout in it, and any floor where the grout is the problem, is where this is worth doing.
What happens to grout that is cracked or missing?
It gets repaired before anything is sealed. Coating over a failed grout line seals the problem in and the coat will let go along that line first. Loose tile is the same answer. If a floor needs enough repair that regrouting makes more sense than sealing, we will tell you that rather than quote around it.
Can it be done while the building is open?
The room being coated has to be closed and stay closed until it is dry, but nothing else in the building stops. Restrooms get done one at a time for that reason. The finish is low odor and low VOC, 46 g/L in gloss and 25 in matte, which is why this work goes into occupied clinics and restaurants overnight rather than waiting for a shutdown.
How is the floor cleaned afterward?
Damp mop with water or a neutral cleaner, and an auto-scrubber with a microfiber pad on the larger runs. What has to stop is anything that leaves a layer behind: no acrylic-enhancing cleaners, no grout sealers on top, and no products meant to be buffed. The grout no longer needs its own cleaning routine, which is usually the part that changes most for a custodial team.

More in Osceola

All the services we offer in Osceola, WI.

The restrooms are rarely the only floor in the building. If the corridors are VCT and the lobby is terrazzo, all of it can be done on the same visit.

Tile & Grout Sealing elsewhere

Tile & Grout Sealing in nearby cities.

Tile and grout sealing in nearby cities.

← See Tile & Grout Sealing details and full service area

Get a quote

Ready for a tile & grout sealing install in Osceola?

Tile and grout sealing in Osceola and the surrounding metro.

  • Free on-site measurement
FREE QUOTE

Tell us about the floor.

Text Dave (fastest) Call